Seamless steel pipe in the method of preventing corrosion and corrosion costs

Seamless steel pipe in the method of preventing corrosion and corrosion costs when the gas depending on different pressure seamless steel pipe to be protected, and the environment is extremely different uses and delivery to positioning. Anti-corrosion coating paint brush to be divided over the conduct, and so again before the paint dry and then brushing the next pass.1 ~ 0. And should brush the outer wall once finished, primer thickness of 0. Brushing force uniform, kicked around, there should be flowing and piled brush and leakage phenomenon. Brushing paint to full uniform, no bubbles, no clots, no flowing, seamless brush. At room temperature, priming and finish the first interval of time should not exceed 24 hours. Inner and outer walls after cleared, artificial rust, rust and iron oxide to the outer surface of the cleaned metal surface rust treatment to meet the requirements grade standards. Primer using manual brushing, according to the first axial Later Zhou Dynasty to the steps.

Surface strength seamless steel pipe, the surface roughness of the original rust into a degree, abrasive coating material to choose, in order to achieve better results, as well as the role of grit etched steel surface, has strengthened steel shot the role of steel surface, mixing abrasive steel shot and grit, for it can be a single layer of epoxy easier to achieve the desired effect. Pipeline corrosion paint brush, depending on the nature of the anti-corrosion paint, paint a good tune, with soft and hard appropriate brush dipped in paint brush pipe surface.2mm, both ends of the pipe is not left bare tube 150mm brush, and easy to weld steel group.

Surface treatment is the impact on the life of the coating, dominating, pipe coating and decided to extend the life of the seamless steel pipe is subjected to surface treatment, it should continue to improve seamless steel surface treatment.

There abrasive roughness is too easy to Cao coating thin, because too deep anchor pattern will form bubbles in the corrosion process, thereby seriously affecting the performance of the coating, such as roughness is too small, it will lead coating impact strength decreased adhesion, abrasive proportion and design is very important, can not rely on large high impact abrasive particles to resolve internal pitting, if you want to rely on the cleaning effect of small particles polished off corrosion products, not only to improve the utilization of the abrasive but also slow down the pipes and nozzles for abrasive wear, the steel surface remains dry, pre-treatment should be cleaned and preheat the surface dirt to be removed by washing the anti-method. Seized by rust after passing inspection, should be within 8 hours of brushing the primer. Brushing steel tube should be dry, dust-free.

Seamless tube, before the outer wall surface rust should be pretreated, the outer surface of the grease, dirt, debris clean, ensure inner and outer walls smooth surface. Primer before painting PVD Coater in strict accordance with the manufacturer's technical documentation requirements for mixing, proportioning, ripening