Unroll a couple of feet Optical vacuum coating machine of film

When you do this you need to make sure that you don't accidentally cut the heated rollers.Now it's time to install the new bottom roll of film. You need to remove the rolls carefully so that the adhesive doesn't come into contact with the rollers. The roll should be in the hex-shaped brake hub on the left and the round hole on the right side.

Roll laminators are helpful machines that make it possible for you to protect and preserve posters, maps, retail displays, and more. (You might burn yourself otherwise. The threading card should come out of the back of the machine. Make sure the screw is tightened and then lower the bottom idle bar. Good luck!However, a lot of people are intimidated by these machines and find them difficult to use. Then, place the core adapter on the shaft and return the retaining collar to its original position.

Repeat the above steps for the top roll. Unroll a couple of feet Optical vacuum coating machine of film and put the idle bar back where it belongs.Turn your laminator on but don't let it get too hot. It will make all the difference. Slide a core adapter into one of the new rolls and them insert a film shaft into the core adapter.

Replace the feed tray to its original position under the bottom roll of film. Removing them can be tricky, especially if the rollers are hot. If this happens, you will end up with a mess. Be sure to look in the instruction manual to find out what film you need. Make sure you feed the card through the rollers so that the film will be properly wrapped around them.There you have it: instructions on how to load film on to your roll laminator. This article will walk you through the process so you can do it with a minimal amount of trouble:

First, you will need to make sure that you have the right film for your machine. The film should be able to unroll from the bottom, much like a roll of paper towels on a rack. Doing so can render your laminator more or less useless. Again, make sure the film will unroll from the bottom or else the machine won't work properly. You will need to pay attention to core size and film thickness. Take your threading card and slide it between the feed tray and the film. If you're having trouble removing the bottom roll, make sure that the locking screw is loosened. Hopefully they will help you out so you can use your machine without any trouble. When it does, remove it and then continue laminating like you normally would.